I have manged to get a few pallets, but I have no idea on how to take them apart. I walked outside with my srewdriver ready for some hard graft and its flat end screws in them. Can anyone please tell me the best way to do this without breaking them.
Put some gloves on and then hold the pallet with one corner pointing towards the ground ie with the top or bottom facing you. Then bang the corner really hard on the ground. Turn it to another corner and repeat the process and it should loosen up.
ray used to put a thick piece of wood under a slat, the other end he stamped on, some of the pieces split but he used them for the ends..we now have a metal pallet stripper :)
I haven't heard of a pallet stripper before, where can you get one from? I thought the pros would use a crowbar.
it's been made for us, like a u shape on the end of a metal bar, we'll photograph it today so's you can see what it looks like ;D
Thanks in advance :)
The pallets I got had nails with ridges on the ends that stops them being pulled out (yes they have a name but I can't remember it!!!). I found the quickest option was saw through the nails with a hacksaw.
They're annular nails, Kea. Sometimes called timber nails, and yes! They are difficult to remove.
A nail remover is an OK item but just to take the odd pallet apart would be pricey.
You could try punching the nail heads through the slat.
Pallets are easy use an hacksaw to slide between the slats and the centres sawing the nails .... no splits or broken bits and no nails sticking out If you tap the centres sideways first one way then the other you will see a gap open just big enough for the hacksaw blade.
All this banging and pulling isnt needed and it makes hard work of an easy job.
mrf94
we get 25 at a time so we use a pallet stripper, also, some of them are 12' long and double sided :)
I'm with mrf94 - you should easily be able to get a hacksaw blade inbetween the planks and the struts. Maybe personal choice, but I find you salvage the most planks this way - I've tried a crowbar and claw hammer but it resulted in too many smashed planks. :o
I remember.. sometime in March 2005.. a really good thread on taking apart pallets.
It is sad that I remember this.. so I have just checked.
11 March 2005! Yippee!
Too many broken planks using crowbars.
I use a hacksaw. Its by far the quickest and easiest way.
You can then always use a centre punch to knock out the left over nails in the planks.
I use 2 chisels a slim one to knock in under slat to hold it up to give space to then use a broader one IE.a bolster type to cut threw nails so slats are complete not broken etc. hope this helps. Mal.
Try the diy catalogue Screwfix for nail removers (www.screwfix.com) and crowbars. All DIYers beware! Once you've read this catalogue you will keep on ordering (it has an appeal like a good seed catalogue.)
I just use a big centre punch and a lump hammer (oh and a glove on my centre punch holding hand ;) ) and punch the ring nails through the plank. I've used hacksaws, jigsaws and prise bars but the punch works the best.
I have ended up sawing pallets with an electric saw. Being a mere girly sometimes you have to take the soft option...
Quote from: pg on March 06, 2008, 08:43:30
Try the diy catalogue Screwfix for nail removers (www.screwfix.com) and crowbars. All DIYers beware! Once you've read this catalogue you will keep on ordering (it has an appeal like a good seed catalogue.)
Screwfix and Tooledup.com - nearly as dangerous and seed sites.