Allotments 4 All
Produce => Under Glass => Topic started by: chinablue32uk on June 24, 2017, 18:46:31
-
Hello everybody I am a newbie to this forum, had a quick mooch around and I'm impressed :-) I have a problem which I am hoping some kind person can help me with I am trying to find instructions on how to fit washers and seals to my x500 flamegun
-
Welcome along, they are very simple to service with very few parts, it is cheapest to buy spares direct from sheen, they are in Nottingham and if you give them a ring they are very helpful 0115 927 2321. I get all my spares from them and they are around 50% cheaper than anywhere else.
-
Thanks Dave, I think I will be ok with the large washer that goes on the main plunger thingy but where does that small one go I have order a washer pack from ebay there is 2 lge washers and a very small o ring
-
Suspect it may be to sit on the pump spindle inside the cap to prevent fuel splilling out. The pump thingy should unscrew(!) to fit.
-
I think the small washer goes on the control tap shaft, take off the control wheel then the top nut, slide the ring on the shaft (remove old one if fitted). :coffee2:
-
Thank you to both of you :-)
-
:BangHead: Does anyone know how you change the non return valve the one at the bottow of the pump chamber??
-
It requires a tool from sheen, you will have to give them a ring.
-
its the tool under the wick on this picture https://www.amazon.co.uk/X300-Sheen-Flame-Flamegun-Service/dp/B004OJDUUK
-
Thanks again
:blob7:
-
:BangHead: Does anyone know how you change the nonreturn valve the one at the bottom of the pump chamber??
Use a reversed socket extension.
John